RE: compile fails solaris-10

?
Thomas,

thank you for the advise. I did as you suggested and re-ran the configure in a clean directory. The first run of make seemed to get further in the build process before it failed. So I took a chance and used the Solaris make (/usr/ccs/bin/make) rather than the GNU version and in fact the mini-agent build completed on the second attempt.

I'm not certain if the problem is solely related to the version of make, or if there was some corruption in my initial build directory. Currently I'm trying a new full build of the agent, again with the Solaris make. If that succeeds, my problems would indeed point back to the make or the arguments I used on my prior builds.

-thanks for your help.


Ray Licon
AT&T WEST
Advanced Technical Support
310-762-6968

________________________________

From: Thomas Anders [mailto:thomas.anders@blue-cable.de]
Sent: Sun 12/23/2007 1:15 PM
To: LICON, RAY (ATTPB)
Cc: net-snmp-users@lists.sourceforge.net
Subject: Re: compile fails solaris-10



LICON, RAY (ATTPB) wrote:
> ./configure --with-perl-modules \
> --build=sparc-sun-solaris2.10 \
> --enable-mini-agent \
> --with-out-mib-modules=\"ucd-snmp\" \
> --enable-mib-config-checking

Can you please start again from scratch by unpacking the source to a new
directory, run

./configure --enable-mini-agent

and report back? FWIW, this works fine for me with 5.4.1 on Solaris 10.


Cheers,
Thomas



-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
Net-snmp-users@lists.sourceforge.net
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/...net-snmp-users