Re: Solaris 10 - Counter64 values are not shown

Hello Thomas,

I've built it from scratch again, included the config of section 10.
Unfortunately, snmpd doesn' t start cleanly anymore:


error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)
error on subcontainer 'interface container' insert (-1)





On Tuesday 11 December 2007, Thomas Anders wrote:
> Frank Munsche wrote:
> > So finally, I've built the 5.4.1 from source (32 bit), but the result
> > remains the same. No counter64.
>
> You need to change your compile-time configuration. See the section "10.
> MIB rewrites for IF-MIB, TCP-MIB and UDP-MIB" in README.solaris (as shipped
> with 5.4.1).
>
>
> +Thomas



-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Net-snmp-users mailing list
Net-snmp-users@lists.sourceforge.net
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/...net-snmp-users