(Wireless) LAN access working. WAN (remote) web access not working!

Calling all Linux wizards to sprinkle some magic and help!

The Problem:
================================================== ======================
I have LAN access but cannot access any remote (WAN) host (or
website).

Examples:
--------
What I CAN do:
a) Able to ping router on 192.168.2.1
b) Able to ping colleague's PC 192.168.2.2
c) Able to configure router using web interface on 192.168.2.1 fine.

What I CANNOT do:
http://www.google.co.uk (Error = "www.google.co.uk could not be found.
Please check the name and try again.")
================================================== ======================


Configuration:
--------------
Linux Suse 9.2

Belkin ADSL Modem with Built-in Wireless Router
Model: F5D7630-4A (ver 1212uk)

D-Link DWL-610 Wireless PCMCIA Card
Driver: DriverLoader

Network:
DHCP Enabled
Infrastructure
Channel 11
IP Forwarding ON
128 bit WEP (enabled) HEX
Gateway 192.168.2.1
ESSID belkin54g


Troubleshooting
----------------
Failed attempts:
X) I've disabled the firewall.
X) I've disabled WEP.
x) I've upgraded router's firmware.
x) Various command-line utilities (see below)


(Console Output):

Traceroute
----------

(Using DNS)
localhost:~# traceroute www.google.co.uk <return>
www.google.co.uk: Temporary failure in name resolution

(Using IP Address)
localhost:~# traceroute 66.102.9.104 <return>
traceroute to 66.102.9.104 (66.102.9.104), 30 hops max, 40 byte
packets
Unable to connect to 66.102.9.104: Network is unreachable


IWCONFIG
---------
localhost:~# iwconfig <return>

wlan0 IEEE 802.11-DS ESSID:"belkin54g" Nickname:"atlantis"
Mode:Managed Frequency:2.462 GHz Access Point:
00:20:E1:D4:1C:B2
Bit Rate=11 Mb/s Tx-Power=20 dBm
RTS thr:off Fragment thr:off
Encryption key:<KEY> Security mode:restricted
Power Management:off
Link Quality:35/94 Signal level:-51 dBm Noise level:-154
dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

IFCONFIG
---------
localhost:~# ifconfig <return>

wlan0 Link encap:Ethernet HWaddr 00:12:66:58:23:1C
inet addr:192.168.2.3 Bcast:192.168.2.255
Mask:255.255.255.0
inet6 addr: fe80::20d:88ff:fe58:531c/64 Scope:Link
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500
Metric:1
RX packets:530 errors:0 dropped:0 overruns:0 frame:0
TX packets:590 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:195057 (190.4 Kb) TX bytes:56885 (55.5 Kb)

IFUP
-----
localhost:~# ifup wlan0 <return>

wlan0 device: D-Link System Inc DWL-510 2.4GHz Wireless PCI
Adapter (rev 20)
wlan0 configuration: wlan-id-00:12:66:58:23:1C
Starting DHCP Client Daemon on wlan0... . IP/Netmask: 192.168.2.3 /
255.255.255.0

RESOLV.CONF
Contents of /etc/resolv.conf (actual IP addresses are of course
different):

search home
nameserver 192.168.168.1
nameserver 192.168.168.8

Godffrey wrote:

> Calling all Linux wizards to sprinkle some magic and help!
>
> The Problem:
>
================================================== ======================
> I have LAN access but cannot access any remote (WAN) host (or
> website).
>
> Examples:
> --------
> What I CAN do:
> a) Able to ping router on 192.168.2.1
> b) Able to ping colleague's PC 192.168.2.2
> c) Able to configure router using web interface on 192.168.2.1 fine.
>
> What I CANNOT do:
> http://www.google.co.uk (Error = "www.google.co.uk could not be found.
> Please check the name and try again.")
[...]
>
> (Using DNS)
> localhost:~# traceroute www.google.co.uk <return>
> www.google.co.uk: Temporary failure in name resolution
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ ^^^^^^^
Fix your DNS setup.