SLIP Configuration settings

Hello again from Gregg C Levine
Here's my problem, my laptop normally runs Linux, and I've got an earlier box
running DOS 3.3. Under DOS 6.2 I can communicate using packet drivers over the
serial ports between both computers.

However, for a project, I need to configure the laptop to allow SLIP access via that
same serial port. Do any of you bright people out here, have any suggestions?
Code, and the usual places for HOWTO documentation appreciated. The Linux
distribution on the laptop is Slackware 8.0.
Gregg C Levine drwho8 atsign att dot net
This message is sponsored by the crew of the Enterprise NCC-1701, the best in the
business. But you already knew that.