solaris and ipfilter 4.1.8

Ok. I am sooo close here, but cannot figure out whats missing...
I use pppd to connect pppoe to my ISP and I see the sppp0 created and
that looks fine. So I think my ppp config is cool. I have 8 static
IPs with 5 routeable...for sake of discussion that is 207.227.112.169/29
with 207.227.112.174 being the router IP:

I have setup ipnat as such:
(keep it simple to start)

map sppp0 192.168.82.0/24 -> 207.227.112.169/32 portmap tcp/udp auto
map sppp0 192.168.82.0/24 -> 207.227.112.169/32

This ideally should send ANY traffic out from my clients to the WAN
using that specific public IP.

then I did a basic ipfilter:

=========================================
bge0=lan interface on router
bge1=interface to DSL modem

# Allow traffic on lo0/bge0 to pass unimpeded
pass in quick on lo0 all
pass out quick on lo0 all
pass in quick on bge0 all
pass out quick on bge0 all
# --------------------------------------------------------------
# That which is not explicitly allowed is forbidden
block in log on sppp0 all
# --------------------------------------------------------------
# TCP/UDP Protocols
pass out quick on sppp0 proto tcp from 192.168.82.0/24 to any keep state
pass out quick on sppp0 proto udp from 192.168.82.0/24 to any keep state
============================================

again real simple for testing.

Well, I startup ppp and then pfil and ipfilter - all run under SMF
with no errors..so I am cool there.

However, the only machine that actually has outside access is the
router itself and it assumes the router IP (which I dont even map at
this time).

ipnat -l:
# ipnat -l
List of active MAP/Redirect filters:
map sppp0 192.168.82.0/24 -> 207.227.112.169/32 portmap tcp/udp auto
map sppp0 192.168.82.0/24 -> 207.227.112.169/32

List of active sessions:

ipstat -hio:
# ipfstat -hio
0 pass out quick on lo0 all
168 pass out quick on bge0 all
0 pass out quick on sppp0 proto tcp from 192.168.82.0/24 to any keep state
0 pass out quick on sppp0 proto udp from 192.168.82.0/24 to any keep state
0 pass in quick on lo0 all
284 pass in quick on bge0 all
0 block in log on sppp0 all


....so it looks like I did things right...so what am I missing?

I added 'ifconfig bge0 router' and even then tried 'ifconfig sppp0
router' to force ip_forwarding on..and it made no difference.

any thought or how I go about trying to see what stooopid thing I am missing?


Jeff